In the Linux kernel, the following vulnerability has been resolved: ipv6: annotate data-race in ndisc_router_discovery() syzbot found that ndisc_router_discovery() could read and write in6_dev->ra_mtu without holding a lock [1] This looks fine, IFLA_INET6_RA_MTU is best effort. Add READ_ONCE()/WRITE_ONCE() to document the race. Note that we might also reject illegal MTU values (mtu < IPV6_MIN_MTU || mtu > skb->dev->mtu) in a future patch. [1] BUG: KCSAN: data-race in ndisc_router_discovery
In the Linux kernel, the following vulnerability has been resolved: interconnect: debugfs: initialize src_node and dst_node to empty strings The debugfs_create_str() API assumes that the string pointer is either NULL or points to valid kmalloc() memory. Leaving the pointer uninitialized can cause problems. Initialize src_node and dst_node to empty strings before creating the debugfs entries to guarantee that reads and writes are safe.
In the Linux kernel, the following vulnerability has been resolved: igc: Reduce TSN TX packet buffer from 7KB to 5KB per queue The previous 7 KB per queue caused TX unit hangs under heavy timestamping load. Reducing to 5 KB avoids these hangs and matches the TSN recommendation in I225/I226 SW User Manual Section 7.5.4. The 8 KB "freed" by this change is currently unused. This reduction is not expected to impact throughput, as the i226 is PCIe-limited for small TSN packets rather than TX-buffe
In the Linux kernel, the following vulnerability has been resolved: mISDN: annotate data-race around dev->work dev->work can re read locklessly in mISDN_read() and mISDN_poll(). Add READ_ONCE()/WRITE_ONCE() annotations. BUG: KCSAN: data-race in mISDN_ioctl / mISDN_read write to 0xffff88812d848280 of 4 bytes by task 10864 on cpu 1: misdn_add_timer drivers/isdn/mISDN/timerdev.c:175 [inline] mISDN_ioctl+0x2fb/0x550 drivers/isdn/mISDN/timerdev.c:233 vfs_ioctl fs/ioctl.c:51 [inline] __do_
In the Linux kernel, the following vulnerability has been resolved: l2tp: avoid one data-race in l2tp_tunnel_del_work() We should read sk->sk_socket only when dealing with kernel sockets. syzbot reported the following data-race: BUG: KCSAN: data-race in l2tp_tunnel_del_work / sk_common_release write to 0xffff88811c182b20 of 8 bytes by task 5365 on cpu 0: sk_set_socket include/net/sock.h:2092 [inline] sock_orphan include/net/sock.h:2118 [inline] sk_common_release+0xae/0x230 net/core/so
In the Linux kernel, the following vulnerability has been resolved: bonding: provide a net pointer to __skb_flow_dissect() After 3cbf4ffba5ee ("net: plumb network namespace into __skb_flow_dissect") we have to provide a net pointer to __skb_flow_dissect(), either via skb->dev, skb->sk, or a user provided pointer. In the following case, syzbot was able to cook a bare skb. WARNING: net/core/flow_dissector.c:1131 at __skb_flow_dissect+0xb57/0x68b0 net/core/flow_dissector.c:1131, CPU#1: syz.2.14
In the Linux kernel, the following vulnerability has been resolved: rxrpc: Fix data-race warning and potential load/store tearing Fix the following: BUG: KCSAN: data-race in rxrpc_peer_keepalive_worker / rxrpc_send_data_packet which is reporting an issue with the reads and writes to ->last_tx_at in: conn->peer->last_tx_at = ktime_get_seconds(); and: keepalive_at = peer->last_tx_at + RXRPC_KEEPALIVE_TIME; The lockless accesses to these to values aren't actually a p
In the Linux kernel, the following vulnerability has been resolved: ice: add missing ice_deinit_hw() in devlink reinit path devlink-reload results in ice_init_hw failed error, and then removing the ice driver causes a NULL pointer dereference. [ +0.102213] ice 0000:ca:00.0: ice_init_hw failed: -16 ... [ +0.000001] Call Trace: [ +0.000003] <TASK> [ +0.000006] ice_unload+0x8f/0x100 [ice] [ +0.000081] ice_remove+0xba/0x300 [ice] Commit 1390b8b3d2be ("ice: remove duplicate call to ice_de
In the Linux kernel, the following vulnerability has been resolved: pmdomain: imx8m-blk-ctrl: Remove separate rst and clk mask for 8mq vpu For i.MX8MQ platform, the ADB in the VPUMIX domain has no separate reset and clock enable bits, but is ungated and reset together with the VPUs. So we can't reset G1 or G2 separately, it may led to the system hang. Remove rst_mask and clk_mask of imx8mq_vpu_blk_ctl_domain_data. Let imx8mq_vpu_power_notifier() do really vpu reset.
In the Linux kernel, the following vulnerability has been resolved: serial: Fix not set tty->port race condition Revert commit bfc467db60b7 ("serial: remove redundant tty_port_link_device()") because the tty_port_link_device() is not redundant: the tty->port has to be confured before we call uart_configure_port(), otherwise user-space can open console without TTY linked to the driver. This tty_port_link_device() was added explicitly to avoid this exact issue in commit fb2b90014d78 ("tty: link
In the Linux kernel, the following vulnerability has been resolved: arm64/fpsimd: ptrace: Fix SVE writes on !SME systems When SVE is supported but SME is not supported, a ptrace write to the NT_ARM_SVE regset can place the tracee into an invalid state where (non-streaming) SVE register data is stored in FP_STATE_SVE format but TIF_SVE is clear. This can result in a later warning from fpsimd_restore_current_state(), e.g. WARNING: CPU: 0 PID: 7214 at arch/arm64/kernel/fpsimd.c:383 fpsimd_rest
In the Linux kernel, the following vulnerability has been resolved: io_uring/io-wq: check IO_WQ_BIT_EXIT inside work run loop Currently this is checked before running the pending work. Normally this is quite fine, as work items either end up blocking (which will create a new worker for other items), or they complete fairly quickly. But syzbot reports an issue where io-wq takes seemingly forever to exit, and with a bit of debugging, this turns out to be because it queues a bunch of big (2GB - 4
In the Linux kernel, the following vulnerability has been resolved: mmc: sdhci-of-dwcmshc: Prevent illegal clock reduction in HS200/HS400 mode When operating in HS200 or HS400 timing modes, reducing the clock frequency below 52MHz will lead to link broken as the Rockchip DWC MSHC controller requires maintaining a minimum clock of 52MHz in these modes. Add a check to prevent illegal clock reduction through debugfs: root@debian:/# echo 50000000 > /sys/kernel/debug/mmc0/clock root@debian:/# [
The Media Library Folders plugin for WordPress is vulnerable to Insecure Direct Object Reference in all versions up to, and including, 8.3.6 via the delete_maxgalleria_media() and maxgalleria_rename_image() functions due to missing validation on a user controlled key. This makes it possible for authenticated attackers, with Author-level access and above, to delete or rename attachments owned by other users (including administrators). The rename flow also deletes all postmeta for the target attac
The Essential Addons for Elementor – Popular Elementor Templates & Widgets plugin for WordPress is vulnerable to Stored Cross-Site Scripting via the plugin's Info Box widget in all versions up to, and including, 6.5.9 due to insufficient input sanitization and output escaping on user supplied attributes. This makes it possible for authenticated attackers, with contributor-level access and above, to inject arbitrary web scripts in pages that will execute whenever a user accesses an injected page.
The Mail Mint plugin for WordPress is vulnerable to blind SQL Injection via the 'forms', 'automation', 'email/templates', and 'contacts/import/tutorlms/map' API endpoints in all versions up to, and including, 1.19.2 . This is due to insufficient escaping on the user supplied 'order-by', 'order-type', and 'selectedCourses' parameters and lack of sufficient preparation on the existing SQL queries. This makes it possible for authenticated attackers, with administrator level access and above, to app
The Modula Image Gallery – Photo Grid & Video Gallery plugin for WordPress is vulnerable to authorization bypass in all versions up to, and including, 2.13.6. This is due to the plugin not properly verifying that a user is authorized to modify specific posts before updating them via the REST API. This makes it possible for authenticated attackers, with contributor level access and above, to update the title, excerpt, and content of arbitrary posts by passing post IDs in the modulaImages field wh
The MP3 Audio Player – Music Player, Podcast Player & Radio by Sonaar plugin for WordPress is vulnerable to Server-Side Request Forgery in versions 5.3 to 5.10 via the 'load_lyrics_ajax_callback' function. This makes it possible for authenticated attackers, with author level access and above, to make web requests to arbitrary locations originating from the web application and can be used to query and modify information from internal services.
The myCred plugin for WordPress is vulnerable to Stored Cross-Site Scripting via the plugin's 'mycred_load_coupon' shortcode in all versions up to, and including, 2.9.7.3 due to insufficient input sanitization and output escaping on user supplied attributes. This makes it possible for authenticated attackers, with contributor level access and above, to inject arbitrary web scripts in pages that will execute whenever a user accesses an injected page.
The Smart Forms plugin for WordPress is vulnerable to unauthorized access of data due to a missing capability check on the 'rednao_smart_forms_get_campaigns' AJAX action in all versions up to, and including, 2.6.99. This makes it possible for authenticated attackers, with Subscriber-level access and above, to retrieve donation campaign data including campaign IDs and names.