Security Feed

In the Linux kernel, the following vulnerability has been resolved: wifi: ath12k: fix dp_link_peer dangling references on AP vdev rollback ath12k_mac_vdev_create() for an AP vdev creates the bss self-peer via ath12k_peer_create(), which finishes by calling ath12k_dp_link_peer_assign() to publish the dp_link_peer in the dp_hw->dp_peers[peerid_index] RCU table, in the dp_peer's link_peers[] array, and in the per-addr rhashtable. If a step after ath12k_peer_create() fails the function jumps to e

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Publish channel state before callbacks Transport setup can enable callbacks before the setup routine returns. mailbox_chan_setup() registers the mailbox client with mbox_request_channel(), and the mailbox controller startup path can enable interrupt delivery before SCMI mailbox channel state has been published. Similarly, smc_chan_setup() requests the optional A2P completion IRQ before the SMC transport has

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Unregister device notifier before IDR teardown The requested-devices notifier looks up protocol fwnodes from the active_protocols IDR. During remove, unregister the notifier before releasing and destroying active_protocols so no notifier callback can race with the IDR teardown. Keep the bus notifier registered until after the protocol state is torn down, matching the existing remove ordering for SCMI bus u

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Quiesce notifications before teardown scmi_notification_exit() clears and releases the notification instance, but transport callbacks can still deliver incoming notifications until the TX/RX channels are freed. During remove, an RX interrupt in that window can enter scmi_notify() while notification state is being torn down and then dereference freed memory. The same ordering exists on the probe error path a

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Clean up channels on setup failure scmi_channels_setup() can fail after the common BASE channel or earlier protocol channels have already been registered in the TX/RX IDRs. Route this failure through the existing channel cleanup label so the transport channels, transport devices and IDR state created before the failure are released before the probe error path frees the SCMI instance ID.

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Free transport channel on IDR failure If transport channel setup succeeds but the following IDR insertion fails, the error path destroys the transport device and frees the channel info without invoking the transport cleanup callback. Call chan_free() before destroying the device so transport specific resources such as IRQs, mailbox channels and mapped shared memory are released consistently with the normal

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Avoid IDR updates while cleaning channels scmi_cleanup_channels() walks the TX/RX channel IDRs with idr_for_each() to free transport resources and destroy the dedicated transport devices before calling idr_destroy(). The destroy callback removed each entry from the same IDR being walked. That is not needed for this cleanup path, and it is unsafe because idr_for_each() has not advanced its radix-tree iterat

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Reject out of range DT protocol IDs SCMI protocol IDs carried in message headers are limited by MSG_PROTOCOL_ID_MASK. The DT parsing paths noticed protocol IDs outside that range, but only logged an error and then kept processing the invalid value. That lets a malformed 32-bit DT reg value reach helpers which take a u8 protocol ID, where it can be truncated and/or treated as a different protocol. For chan

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Drop handle on protocol bind failures The SCMI bus notifier acquires an SCMI handle when the driver core emits BUS_NOTIFY_BIND_DRIVER, before invoking the protocol driver probe callback. The protocol probe path only checks whether sdev->handle is set. If device_link_add() fails after the handle has been acquired, the protocol device can still bind with a valid handle but without the dependency link to the

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Unwind TX receiver mailbox setup failure mailbox_chan_setup() can request an additional unidirectional TX receiver channel after successfully acquiring the primary channel. If that second request fails, the function returns immediately and leaves the primary channel allocated. Unwind the primary mailbox channel before returning the error so probe deferral or other setup failures do not leave the channel bu

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Unwind P2A receiver mailbox setup failure mailbox_chan_setup() can request an additional P2A receiver channel after successfully acquiring the primary P2A channel. If that later request fails, the function returns immediately and leaves the primary channel allocated. Unwind the primary mailbox channel before returning the error so probe deferral or other setup failures do not leave the channel busy for lat

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Fix SCMI device destroy lifetimes scmi_child_dev_find() drops the reference returned by device_find_child() before returning the scmi_device pointer. A concurrent unregister can then release the device while the destroy path is still using the returned pointer. Make the lookup helper return the device_find_child() reference and keep it until scmi_device_destroy() has finished unregistering the child. Also

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Fix transport device teardown lookup SCMI transport devices are deliberately excluded from normal SCMI bus matching so protocol drivers cannot bind to the internal transport children. However, scmi_device_destroy() uses the same protocol/name lookup to find devices that must be unregistered during channel teardown. Split the match helper so driver matching still skips transport devices, while explicit chil

In the Linux kernel, the following vulnerability has been resolved: cxl/features: Reject Get Feature count larger than the output buffer cxlctl_get_feature() sizes its output buffer from the user's fwctl_rpc.out_len, but the device is told to write cxl_mbox_get_feat_in.count bytes into rpc_out->payload, which is a separate user-controlled value. Nothing bounds count against out_len, so a small out_len with a large count overflows the kvzalloc()'d buffer. A heap OOB write reachable from FWCTL_R

In the Linux kernel, the following vulnerability has been resolved: cxl/features: Reject Set Features output buffer smaller than the header cxlctl_set_feature() sizes its output buffer from the user's fwctl_rpc.out_len but never checks it is large enough to hold even the fwctl_rpc_cxl_out header. With out_len == 0 , kvzalloc() returns ZERO_SIZE_PTR, which passes the !rpc_out check, the subsequent rpc_out->size = 0 then writes through the poison pointer. Reject requests whose output buffer can

In the Linux kernel, the following vulnerability has been resolved: cxl/features: Clamp Get Feature output size to the remaining buffer cxl_get_feature() reads a feature in a loop but passes a fixed size_out as the output capacity every iteration. On the last partial iteration the buffer has less room left, so a device that returns more than asked can overflow feat_out. Use the per-iter size data_to_rd_size, which already tracks the remaining room, as the output capacity.

In the Linux kernel, the following vulnerability has been resolved: dax/fsdev: clear vmemmap_shift when binding static pgmap Clear pgmap->vmemmap_shift for static DAX devices. When rebinding a static device from device_dax (which may set vmemmap_shift based on alignment) to fsdev_dax, the stale vmemmap_shift persists on the shared pgmap. Explicitly zero it before devm_memremap_pages() so the vmemmap is built for order-0 folios as fsdev requires.

In the Linux kernel, the following vulnerability has been resolved: dax/fsdev: clear pgmap ops and owner on unbind fsdev_dax_probe() sets pgmap->ops = &fsdev_pagemap_ops and pgmap->owner = dev_dax, but nothing ever clears them. For a dynamic device the pgmap is devm-allocated and freed on unbind, so this is harmless. For a static device the pgmap is the shared, long-lived one owned by the dax bus (kill_dev_dax() only NULLs dev_dax->pgmap for the non-static case), and device.c's probe sets only