CVEs

In the Linux kernel, the following vulnerability has been resolved: net: asix: add proper error handling of usb read errors Syzbot once again hit uninit value in asix driver. The problem still the same -- asix_read_cmd() reads less bytes, than was requested by caller. Since all read requests are performed via asix_read_cmd() let's catch usb related error there and add __must_check notation to be sure all callers actually check return value. So, this patch adds sanity check inside asix_read_c

In the Linux kernel, the following vulnerability has been resolved: mt76: mt7921s: fix a possible memory leak in mt7921_load_patch Always release fw data at the end of mt7921_load_patch routine.

In the Linux kernel, the following vulnerability has been resolved: power: supply: ab8500: Fix memory leak in ab8500_fg_sysfs_init kobject_init_and_add() takes reference even when it fails. According to the doc of kobject_init_and_add()： If this function returns an error, kobject_put() must be called to properly clean up the memory associated with the object. Fix memory leak by calling kobject_put().

In the Linux kernel, the following vulnerability has been resolved: drm/bridge: anx7625: Fix overflow issue on reading EDID The length of EDID block can be longer than 256 bytes, so we should use `int` instead of `u8` for the `edid_pos` variable.

In the Linux kernel, the following vulnerability has been resolved: drm/msm/dp: populate connector of struct dp_panel DP CTS test case 4.2.2.6 has valid edid with bad checksum on purpose and expect DP source return correct checksum. During drm edid read, correct edid checksum is calculated and stored at connector::real_edid_checksum. The problem is struct dp_panel::connector never be assigned, instead the connector is stored in struct msm_dp::connector. When we run compliance testing test cas

In the Linux kernel, the following vulnerability has been resolved: dax: make sure inodes are flushed before destroy cache A bug can be triggered by following command $ modprobe nd_pmem && modprobe -r nd_pmem [ 10.060014] BUG dax_cache (Not tainted): Objects remaining in dax_cache on __kmem_cache_shutdown() [ 10.060938] Slab 0x0000000085b729ac objects=9 used=1 fp=0x000000004f5ae469 flags=0x200000000010200(slab|head|node) [ 10.062433] Call Trace: [ 10.062673] dump_stack_lvl+0x34/0x44

In the Linux kernel, the following vulnerability has been resolved: vfio/pci: fix memory leak during D3hot to D0 transition If 'vfio_pci_core_device::needs_pm_restore' is set (PCI device does not have No_Soft_Reset bit set in its PMCSR config register), then the current PCI state will be saved locally in 'vfio_pci_core_device::pm_save' during D0->D3hot transition and same will be restored back during D3hot->D0 transition. For saving the PCI state locally, pci_store_saved_state() is being used

In the Linux kernel, the following vulnerability has been resolved: scsi: pm8001: Fix abort all task initialization In pm80xx_send_abort_all(), the n_elem field of the ccb used is not initialized to 0. This missing initialization sometimes lead to the task completion path seeing the ccb with a non-zero n_elem resulting in the execution of invalid dma_unmap_sg() calls in pm8001_ccb_task_free(), causing a crash such as: [ 197.676341] RIP: 0010:iommu_dma_unmap_sg+0x6d/0x280 [ 197.700204] RSP:

In the Linux kernel, the following vulnerability has been resolved: drm/tegra: Fix reference leak in tegra_dsi_ganged_probe The reference taken by 'of_find_device_by_node()' must be released when not needed anymore. Add put_device() call to fix this.

In the Linux kernel, the following vulnerability has been resolved: powerpc/64s: Don't use DSISR for SLB faults Since commit 46ddcb3950a2 ("powerpc/mm: Show if a bad page fault on data is read or write.") we use page_fault_is_write(regs->dsisr) in __bad_page_fault() to determine if the fault is for a read or write, and change the message printed accordingly. But SLB faults, aka Data Segment Interrupts, don't set DSISR (Data Storage Interrupt Status Register) to a useful value. All ISA version

In the Linux kernel, the following vulnerability has been resolved: ath10k: Fix error handling in ath10k_setup_msa_resources The device_node pointer is returned by of_parse_phandle() with refcount incremented. We should use of_node_put() on it when done. This function only calls of_node_put() in the regular path. And it will cause refcount leak in error path.

In the Linux kernel, the following vulnerability has been resolved: mtd: rawnand: atmel: fix refcount issue in atmel_nand_controller_init The reference counting issue happens in several error handling paths on a refcounted object "nc->dmac". In these paths, the function simply returns the error code, forgetting to balance the reference count of "nc->dmac", increased earlier by dma_request_channel(), which may cause refcount leaks. Fix it by decrementing the refcount of specific object in thos

In the Linux kernel, the following vulnerability has been resolved: mips: cdmm: Fix refcount leak in mips_cdmm_phys_base The of_find_compatible_node() function returns a node pointer with refcount incremented, We should use of_node_put() on it when done Add the missing of_node_put() to release the refcount.

In the Linux kernel, the following vulnerability has been resolved: MIPS: pgalloc: fix memory leak caused by pgd_free() pgd page is freed by generic implementation pgd_free() since commit f9cb654cb550 ("asm-generic: pgalloc: provide generic pgd_free()"), however, there are scenarios that the system uses more than one page as the pgd table, in such cases the generic implementation pgd_free() won't be applicable anymore. For example, when PAGE_SIZE_4KB is enabled and MIPS_VA_BITS_48 is not enabl

In the Linux kernel, the following vulnerability has been resolved: bpf, sockmap: Fix memleak in tcp_bpf_sendmsg while sk msg is full If tcp_bpf_sendmsg() is running while sk msg is full. When sk_msg_alloc() returns -ENOMEM error, tcp_bpf_sendmsg() goes to wait_for_memory. If partial memory has been alloced by sk_msg_alloc(), that is, msg_tx->sg.size is greater than osize after sk_msg_alloc(), memleak occurs. To fix we use sk_msg_trim() to release the allocated memory, then goto wait for memor

In the Linux kernel, the following vulnerability has been resolved: RDMA/irdma: Prevent some integer underflows My static checker complains that: drivers/infiniband/hw/irdma/ctrl.c:3605 irdma_sc_ceq_init() warn: can subtract underflow 'info->dev->hmc_fpm_misc.max_ceqs'? It appears that "info->dev->hmc_fpm_misc.max_ceqs" comes from the firmware in irdma_sc_parse_fpm_query_buf() so, yes, there is a chance that it could be zero. Even if we trust the firmware, it's easy enough to change

In the Linux kernel, the following vulnerability has been resolved: bpf, sockmap: Fix memleak in sk_psock_queue_msg If tcp_bpf_sendmsg is running during a tear down operation we may enqueue data on the ingress msg queue while tear down is trying to free it. sk1 (redirect sk2) sk2 ------------------- --------------- tcp_bpf_sendmsg() tcp_bpf_send_verdict() tcp_bpf_sendmsg_redir() bpf_tcp_ingress() so

In the Linux kernel, the following vulnerability has been resolved: RDMA/mlx5: Fix memory leak in error flow for subscribe event routine In case the second xa_insert() fails, the obj_event is not released. Fix the error unwind flow to free that memory to avoid a memory leak.