CVEs

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb() When unpacking host-supplied NTBs, ncm_unwrap_ntb() checks datagram length against frame_max but does not verify that the datagram fits within the declared block length. Additionally, when decoding multiple NTBs from a single socket buffer, subsequent block lengths are not checked against the actual remaining buffer data. With these checks missing, a malicious U

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer uvc_send_response() builds the UVC control response from a user-supplied struct uvc_request_data: req->length = min_t(unsigned int, uvc->event_length, data->length); ... memcpy(req->buf, data->data, req->length); req->length is clamped to uvc->event_length, which is taken from the host control request wLength (up to UVC_MAX_REQUEST_SIZE, 64), and to data-

In the Linux kernel, the following vulnerability has been resolved: USB: serial: io_edgeport: cap received transmit credits The interrupt-status packet reports transmit credits returned by the device. edge_interrupt_callback() adds the 16-bit value to txCredits without checking maxTxCredits. edge_write() uses txCredits minus the software FIFO count as the amount of data that fits. Since the FIFO is allocated with maxTxCredits bytes, txCredits exceeding maxTxCredits can cause OOB write in ring

In the Linux kernel, the following vulnerability has been resolved: wifi: ath9k: hif_usb: don't dereference hif_dev after re-arming firmware request ath9k_hif_request_firmware() re-arms an asynchronous firmware load via request_firmware_nowait(), passing hif_dev as the completion context, and then still dereferences hif_dev: dev_info(&hif_dev->udev->dev, "ath9k_htc: Firmware %s requested\n", hif_dev->fw_name); The re-armed callback ath9k_hif_usb_firmware_cb() runs on the "events" workque

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix NULL pointer dereference in ath11k_hal_srng_access_begin In ATH11K_QMI_EVENT_FW_READY, ATH11K_FLAG_REGISTERED is set unconditionally even when ath11k_core_qmi_firmware_ready() fails. This leaves the driver in an inconsistent state where initialization is considered complete although the firmware ready handling did not finish successfully. During the subsequent SSR, the driver enters the restart path based on

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within corsairpsu_probe(). If the probe operation fails after "io start" has been initiated, this race condition will result in a uaf vulnerability [1]. CPU0 CPU1 ==== ==== corsairp

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-cpro) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by call

In the Linux kernel, the following vulnerability has been resolved: hwmon: (nzxt-smart2) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by calli

In the Linux kernel, the following vulnerability has been resolved: hwmon: (nzxt-kraken3) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by call

In the Linux kernel, the following vulnerability has been resolved: watchdog: pretimeout: Fix UAF in watchdog_unregister_governor() When a watchdog governor is unregistered, it updates existing watchdog devices that were using this governor by falling back to `default_gov`. If the governor being unregistered is currently set as `default_gov`, the `default_gov` is never cleared. This leads to 2 use-after-free issues: 1. New watchdog devices registered after this point will inherit the dang

In the Linux kernel, the following vulnerability has been resolved: watchdog: airoha: Prevent division by zero when clock frequency is zero clk_get_rate() can return 0 when the clock provider is not properly configured or the clock is unmanaged. The driver uses wdt_freq as a divisor directly in airoha_wdt_probe() to compute max_timeout and in airoha_wdt_get_timeleft() to compute the remaining time, which results in a division by zero. Add a check for wdt_freq == 0 in probe and return -EINVAL

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get() When the first entry in msdu_details has a zero buffer address, the code accesses msdu_details[i - 1] with i == 0, causing a buffer underflow. Fix similarly to ath12k_wifi7_hal_rx_msdu_list_get() by adding a separate check for i == 0 before the main condition to prevent the out-of-bounds access. Found by Linux Verification Center (linuxtesting.org)

In the Linux kernel, the following vulnerability has been resolved: firewire: net: Fix fragmented datagram reassembly fwnet_frag_new() keeps a sorted list of received fragments for a partial datagram. When a new fragment is adjacent to an existing fragment, the code checks whether the new fragment also closes the gap to the next or previous list entry. Those neighbor lookups currently assume that the current fragment always has a real next or previous fragment. At a list edge, the next or pre

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler The firmware-controlled num_msg field (u8, 0-255) drives the loop in ath6kl_wmi_tx_complete_event_rx() without validation against the buffer length. This allows out-of-bounds reads of up to 1020 bytes past the WMI event buffer when the firmware sends an inflated num_msg. Add a check that the buffer is large enough to hold the fixed struct and the num_msg

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware IE lengths in connect event The firmware-controlled beacon_ie_len, assoc_req_len, and assoc_resp_len fields in ath6kl_wmi_connect_event_rx() are not validated against the buffer length. Their sum (up to 765) can exceed the actual WMI event data, causing out-of-bounds reads during IE parsing and state corruption of wmi->is_wmm_enabled. Add a check that the total IE length fits within th

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read When the firmware sends a command response with a length mismatch, carl9170_cmd_callback() logs the mismatch and calls carl9170_restart() but then falls through to memcpy(ar->readbuf, buffer + 4, len - 4). Since len comes from the firmware and can exceed ar->readlen, this copies more data than the readbuf was allocated for. Bound the memcpy to min(len - 4

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: fix OOB read from off-by-two in TX status handler The bounds check in carl9170_tx_process_status() uses `i > ((cmd->hdr.len / 2) + 1)` which is off by two, allowing 2 extra iterations past valid _tx_status entries when the firmware- controlled hdr.ext exceeds hdr.len/2. Fix by using the correct comparison `i >= (cmd->hdr.len / 2)`.

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: fix buffer overflow in rx_stream failover path The failover continuation in carl9170_rx_stream() copies the full tlen from the second USB transfer instead of capping at rx_failover_missing bytes. When both transfers are near maximum size, the total exceeds the 65535-byte failover SKB, triggering skb_over_panic. Limit the copy size to the missing byte count. [Fix checkpatch CHECK:PARENTHESIS_ALIGNMENT]